Product Info Long
Altronix eFlow102NB - Power Supply Charger, Single Output, 12VDC @ 10A, Aux Output, FAI, LinQ2 Ready, 115VAC, Board
Altronix eFlow102NB UL Listed Sub-Assembly power supply/charger converts a 120VAC, 60Hz input into a single 12VDC output. It also offers a suite of features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.
Input Rating
Output
- 12VDC output.
- 10A continuous supply current.
- Aux. power-limited output rated @ 1A (unswitched).
- Over Voltage Protection.
- Filtered and electronically regulated outputs.
Battery Backup
- Built-in charger for sealed lead acid or gel type batteries.
- Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption.
Fire Alarm Disconnect
- Supervised Fire Alarm disconnect (latching or nonlatching) 10K EOL resistor. Operates on a normally open (NO) or normally closed (NC) trigger.
Supervision
- AC fail supervision (form "C" contacts).
- Notification trigger is selectable for 30 seconds (factory set) or 2 hours.
- Battery fail & presence supervision (form "C" contacts).
- Low power shutdown. Shuts down DC output terminals if battery voltage drops below 80% of nominal. Prevents deep battery discharge.
Electrical
Temperature:
- - Operating: 0° C to 49° C (32° F to 120° F).
- - Storage: - 20° C to 70° C ( - 4° F to 158° F).
- Relative Humidity 85% +/- 5%.
- BTU/Hr (approx.): 61 BTU/Hr.
- System AC input VA requirement: 420VA.
Visual Indicators
- Green AC Power LED indicates 120VAC present.
- AC input and DC output LED indicators.
Additional Features
- Short circuit and overload protection.
Dimensions (approximate):
- 4.6"W x 7.5"L x 1.75"H (116.84 mm W x 190.5 mm L x 44.45 mm H).
Weights (approximate):
- Product Weight: 0.85 Lbs. (0.39 kg).
- Shipping Weight: 1 Lbs. (0.45 kg).